Altinex MX2426CV Switch User Manual


 
SWITCHERS
6
APPLICATION DIAGRAM 5
INSTALLATION 6
Step 1. Make sure that the power input is set to
the proper AC voltage for your country.
An incorrect setting can result in unit
damage not covered by warranty.
Step 2. Connect the power cord to the unit and
plug it into the power outlet.
Step 3. Connect the cables from the video
sources (computers) to the input
channels, local monitors to the loop
outputs and connect the output channels
to the display devices (monitors or
projectors. A Shielded, high, quality
coaxial cable is recommended for video
cable runs.
Step 4. Verify that the display and audio
equipment operates properly and results
in perfect images and sound.
CONGRATULATIONS! YOU ARE DONE.
OPERATION 7
7.1 FRONT PANEL CONTROL
The front panel of the MX2426CV offers controls
that are specifically designed for a courtroom
environment. The SOURCE SELECT buttons
allow a user to select between the presentation
systems of the plaintiff or the defendant. The
DISPLAY SELECT section of the switcher allows
a user to turn ON or OFF, display devices
connected to the respective ports. The
RECALL/SAVE section of the control panel
allows a user to store various presets in memory
and recall them at the push of a button. To save
a preset select the outputs to be controlled by
one button and store the preset in any one of four
memories by holding the memory button for 2
seconds. To recall just press the memory button.
7.2 MASTER DISABLE CONTROL
The MX2426CV is also equipped with a master
disable control that allows disabling of the unit.
This port is used to connect the Judge Override
button. See the description below. The
connection is accomplished by connecting one
wire to the OFF pin and the other to the GND pin.
When the OFF pin is shorted to ground, all video
signals are terminated. INPUT SELECT
SECTION
If you experience any problems, please call
1-800-258-4623 or 1-714-990-2300 for
international calls.