Filter
Top Products
DESIGNER SOLUTIONS
400-0520-001
2
PRECAUTIONS / SAFETY WARNINGS 1
Please read this manual carefully before using your
SP107-101 AV Interconnect. Keep this manual
handy for future reference. These safety
instructions are to ensure the long life of your
SP107-101 and to prevent fire and shock hazards.
Please read them carefully and heed all warnings.
1.1 GENERAL
• Unauthorized personnel shall not open the unit.
There are high-voltage components inside.
• Qualified ALTINEX service personnel or their
authorized representatives must perform all
service.
1.2 INSTALLATION PRECAUTIONS
• For best results, place the SP107-101 in a dry
area away from dust.
• To prevent fire or shock, do not expose this unit
to water or moisture. Do not place the
SP107-101 in direct sunlight, near heaters or
heat-radiating appliances, or near any liquid.
Exposure to direct sunlight, smoke, or steam can
harm internal components.
• Handle the SP107-101 carefully. Dropping or
jarring can damage the bezel.
• Never place fingers inside the opening on either
side of the unit. This action could cause injury
due to sharp edges inside.
• Disconnect the SP107-101’s power cord to turn
off the main power. This supplies power to the
AC sockets on the panel. The power outlet
should be installed near the equipment and
should be easily accessible.
• We recommend using wall outlets with a Ground
Fault Circuit Interrupter (GFCI) for maximum
protection.
• Install all cables according to the instructions
found herein. Do not force or pull any cable or
power cord that is attached to the SP107-101.
1.3 CLEANING
• Surfaces should be cleaned with a dry cloth.
Never use strong detergents or solvents such as
alcohol or thinner. Do not use a wet cloth or
water to clean the unit.
1.4 FCC NOTICE
• This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) This device may not cause
harmful interference, and (2) this device must
accept any interference received, including
interference that may cause undesired
operation.
• This equipment has been tested and found to
comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference when the
equipment is operated in a commercial
environment. This equipment generates, uses,
and can radiate radio frequency energy and, if
not installed and used in accordance with the
instructions found herein, may cause harmful
interference to radio communications. Operation
of this equipment in a residential area is likely to
cause harmful interference in which case the
user will be required to correct the interference
at his expense.
• Any changes or modifications to the unit not
expressly approved by ALTINEX, Inc. could void
the user’s authority to operate the equipment.