Altinex TNP142 Network Card User Manual


 
TABLETOP SOLUTIONS
400-0434-003 2
PRECAUTIONS / SAFETY WARNINGS 1
Please read this manual carefully before using your
Tilt ‘N Plug Jr. Interconnect Box. Keep this manual
handy for future reference. These safety
instructions are to ensure the long life of your
Tilt ‘N Plug Jr. and to prevent fire and shock
hazards. Please read them carefully and heed all
warnings.
1.1 GENERAL
Unauthorized personnel shall not open the unit
as there are high-voltage components inside.
Qualified ALTINEX service personnel, or their
authorized representatives must perform all
service.
1.2 INSTALLATION PRECAUTIONS
For best results, place the Tilt ‘N Plug Jr.
Interconnect Box in a dry area away from dust.
To prevent fire or shock, do not expose this unit
to water or moisture. Do not place the
Tilt ‘N Plug Jr. in direct sunlight, near heaters
or heat-radiating appliances, or near any liquid.
Exposure to direct sunlight, smoke, or steam
can harm internal components.
Handle the Tilt ‘N Plug Jr. carefully. Dropping
or jarring can damage the bezel.
Never place fingers inside the opening on either
side of the unit. This action could cause injury
due to sharp edges inside.
Do not place heavy objects on top of the
Tilt ‘N Plug Jr. Do not use excessive force to
push down on the top of the unit.
Disconnect the Tilt ‘N Plug Jr.’s power cord to
turn off the main power. This supplies power to
the power socket on the pop-up panel. The
power outlet should be installed near the
equipment and should be easily accessible.
We recommend using wall outlets with a Ground
Fault Circuit Interrupter (GFCI) for maximum
protection.
Install all cables according to the instructions
found herein. Do not force or pull out any cable
or power cord that is attached to the
Tilt ‘N Plug Jr.
1.3 CLEANING
Surfaces should be cleaned with a dry cloth.
Never use strong detergents or solvents such as
alcohol or thinner. Do not use a wet cloth or
water to clean the unit.
1.4 FCC NOTICE
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) This device may not cause
harmful interference, and (2) this device must
accept any interference received, including
interference that may cause undesired
operation.
This equipment has been tested and found to
comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference when the
equipment is operated in a commercial
environment. This equipment generates, uses,
and can radiate radio frequency energy and, if
not installed and used in accordance with the
instructions within this manual, may cause
harmful interference to radio communications.
Operation of this equipment in a residential area
is likely to cause harmful interference in which
case the user will be required to correct the
interference at his expense.
Any changes or modifications to the unit not
expressly approved by ALTINEX, Inc. could void
the user’s authority to operate the equipment.