Filter
Top Products
Pocket Scan™ Introduction
WARNINGS:
• Do not spill water or other liquids in to or on to your unit.
• Be sure that the local power outlet match that of the
required voltage for your unit.
• Do not attempt to operate this unit if the power cord
has been frayed or broken. Please route your power
cord out of the way of foot trafc.
• Do not attempt to remove or break off the ground
prong from the electrical cord. This prong is used to
reduce the risk of electrical shock and re in case of an
internal short.
• Disconnect from main power before making any type
of connection.
• Do not remove the top cover under any conditions.
There are no user serviceable parts inside.
• Never plug this unit in to a dimmer pack
• Always be sure to mount this unit in an area that will
allow proper ventilation. Allow about 6” (15cm)
between this device and a wall.
• Do not attempt to operate this unit, if it becomes
damaged in any way.
• Never operate this unit when it’s cover is removed.
• To reduce the risk of electrical shock or re, do not
expose this unit rain or moisture
• This unit is intended for indoor use only, use of this
product outdoors voids all warranties.
• During long periods of non-use, disconnect the unit’s
main power.
• Always mount this unit in safe and stable matter.
©American DJ Supply® - www.americandj.com - Pocket Scan™ Instruction Manual Page 4 ©American DJ Supply® - www.americandj.com - Pocket Scan™ Instruction Manual Page 13
Listed below are a few common problems the user may
encounter, with solutions.
No light from the unit;
1. Check if the ‘Power On’ (red) LED is lit and the fan is
running. If not, there is no main supply.
2. Check the fuse in the back panel.
3. Check if lamp is lit. The user should be able to see some
light escape through the fan. If power is present but the
lamp is not lit, lamp may need to be replaced.
Note: The unit has been designed to shut the lamp down
after 60 seconds of inactivity. This is a way of extending
lamp life, be assured this is not a problem with the fixture.
Unit not responding to DMX;
1. If the RED LED in the LCD is flashing, the unit is definitely
receiving DMX
2. Check for prper DMX addressing.
3. If the DMX LED is not lit, check that the DMX cables are
connected properly and are wired correctly (pin 3 is
‘hot’; on some other DMX devices pin 2 may be ‘hot’).
Also, check that all cables are connected to the right
connectors; it does matter which way the inputs and
outputs are connected.
4. If it is a bad connection, the RED LED may flash when
cables are wiggled (but remember it may also be the
unit sensing audio!)
5. If DMX connectors are fairly short, ordinary microphone
cables may be used. For longer runs, this may cause
Pocket Scan™ Trouble Shooting