Filter
Top Products
4 990-5518 03/02
SLG Enclosure Installation
Locate an installation site and setup the concrete pad according to local building code requirements.
See the figure below for pad details.
1. Remove the rear panel of the ground mount skirt (four, #8 Phillips head screws).
2. Pull the Coax and AC lines through the sweeps.
3. Set the enclosure onto the rods set in the concrete pad.
4. Secure the enclosure using lockwashers and nuts.
5. Apply a sealant to the concrete pad/ ground skirt to seal the interior of the enclosure against
moisture and insects.
Use 3/8” threaded rod,
“J” hooks, or
foundation bolts in the
concrete (1.27 cm).