Filter
Top Products
Silcon
Management
Quick Start Guide
www.apcc.com
2
1 3
Contents
Introduction
Overview
This document provides quick instructions for setting up the
management of your installed
APC
Silcon
DP300E
series
UPS
.
The setup will involve:
• Mounting the
APC Silcon
Triple Chassis (
AP9604S)
• Connecting the chassis to the
UPS
and to your network
• Configuring the required settings of your Silcon
management card
• Using your Web browser to connect to the network
interface of your Silcon management card
• Downloading and installing PowerChute network
shutdown software
• Testing your configuration
For more
information
All the information needed to set up the management of your
UPS
is contained in this quick start guide. If you need
additional information, please consult the appropriate
document listed below:
• Printed user guide for your Silcon
DP300E
Series UPS
• Triple Chassis for Silcon DP300E Series UPSs printed
installation manual
• Web/
SNMP
Management Card Installation and Quick
Start Guide on the
CD
(
PDF
)
• Web/
SNMP
Management Card User Guide on the
CD
(PDF)
• Web/
SNMP
Management Card Release Notes on the
CD
(
PDF
)
Installation
Installation
options
You can install the Silcon Triple Chassis in one of three ways.
It can be:
• placed on a desktop
• mounted in a NetShelter enclosure or other 19" rack
• mounted on a wall
Placing on a
desktop
1 Choose a permanent location for the chassis. Make sure that
the rear panel of the chassis is accessible.
Note: We recommend that you not place the chassis on top of
the
UPS
to ensure proper airflow to the
UPS
.
2 Continue with “Connecting the chassis” on page 4.
Mounting in an
enclosure
1 Remove the rubber feet from the bottom of the chassis.
2 Fasten each rack-mount bracket (supplied) to the chassis as
shown, using the two flat head mounting screws (supplied)
and a #2 Phillips screwdriver.
Note: The mounting brackets attach at various hole positions
on the side of the chassis. Choose a position that will
prevent connected cables from being pinched by the
door. If more than two mounting holes are aligned, use
the pairs that are the farthest apart.
3 Attach the assembly to the rack using four caged nuts and
mounting screws supplied with your NetShelter enclosure.
(See the figure on the next page.)
Note: Refer to the user documentation supplied with your
enclosure or rack for more detailed mounting
instructions.
Continued on next page
Installation continued
Mounting in an
enclosure,
continued
4 Continue with “Connecting the chassis” on page 4.
Mounting on a
wall
1 Fasten the wall mounting brackets (supplied) to the chassis,
using the flat head screws (supplied) and a #2 Phillips
screwdriver.
2 Attach the assembly to the wall using mounting hardware
(not supplied) that is sturdy enough to support the weight of
the chassis.
3 Continue with “Connecting the chassis” on page 4.
Introduction 1
Overview 1
For more information 1
Installation 2
Installation options 2
Placing on a desktop 2
Mounting in an enclosure 2
Mounting on a wall 3
Connection 4
Connecting the chassis 4
LED descriptions 5
Configuration 6
Configuring network settings 6
Configuration options 6
Management Card Wizard 6
Accessing the network interface 7
For more information 8
Setting up network shutdown software 8
Testing your configuration 8
Enabling remote control 9
Silcon Customer Support:
Toll-free
U. S. & Canada 1-877-287-7835
APC Customer Support:
Toll-free
Denmark 800 18 153
France 0 800 906 483
Germany 01300818907
Ireland 1 800 702000 x 2045
Italy 1678 74731
Japan 0120-80-60-90
U. K. 0800 132990
Entire contents copyright© 2000 AmericanPower Conversion. Allrights reserved.
Reproduction inwhole or in partwithout permission isprohibited.
APC, Smart-UPS,Matrix UPS, Symmetra, PowerArray,and PowerChute are alltrademarks or registered
trademarks of APC.All other trademarks,product names, andcorporate names arethe property oftheir
respective ownersand are usedfor informational purposesonly.
990-0149 4/00
APCCustomerSupport:
Toll-free
Austria 0660 6480
Belgium 0800 15063
Czech Republic 0 800 102063
Finland 9800 13 374
Holland 0800 0224655
Hungary 00800 12221
Israel 177 353 2206
Luxembourg 0800 2091
Norway 800 11 632
Poland 00800 353 1202
Portugal 050 553182
South Africa 0800 994206
Spain 900 95 35 33
Sweden 020 795 419
Switzerland 0800 556177
Turkey 0800 35390275
Online Customer Support:
Addresses:
American Power Conversion Corporation
132 Fairgrounds Road
P. O. Box 278
West Kingston, Rhode Island 02892
USA
American Power Conversion Corporation
Ballybritt Business Park
Galway
Ireland
U.S. & Canada http://www.apcc.com/support