Filter
Top Products
BROAD SCAN (HD/SDI) Chapter 4 : FRONT PANEL DISPLAY MENU DESCRIPTION (continued)
PAGE 23
4-5. FUNCTIONS DESCRIPTION (continued)
[Genlock Tune].
This function is available only if the Output format selected is Genlock, and if a correct genlock signal is detected
on the GENLOCK INPUT connector.
[H Phase]: This function allows adjusting the genlock horizontal phase. Adjust with + ENTER.
[SC. Phase]: This function allows adjusting the genlock Subcarrier phase. (Available with Analog SDTV
Genlock signal only). Adjust with + ENTER.
[Type] Available for SDTV output format.
Select the needed signal available on the RGB/YUV output
[RGBS]: RGB/S video output.
[RGsB]: RGB with Sync on Green video output.
[YUV]: Component video output.
[Pedestal] Available for NTSC output format.
Add a pedestal to the NTSC output format.
[Test pattern]
Select one item with + ENTER.
[Grey Scale]: Displays onto the output a grey scale pattern.
[Color bar]: Displays onto the output a color bar pattern.
[Grid]: Displays onto the output a grid pattern.
[SMPTE]: Displays onto the output a SMPTE pattern
[No]: turns OFF the test pattern.
[IMAGE]
[Auto Centering]
This function centers automatically the image source in the screen and then for the RGB signal, performs pixel
clock & phase adjustments.
[Optimize]
[Clock]: Manual adjustment of the pixel clock.
[Phase]: Manual adjustment of the pixel phase.
[Aspect in]
Select the Aspect Ratio of your input source with + ENTER.
[4/3 standard]: 4/3 input format.
[16/9]: 16/9 input format (computer).
[Aspect out]
Select one of the following output aspect ratio with + ENTER.
[Standard]: The entire image and the aspect ratio are preserved.
[Crop]: The image is zoomed without deformation to fill the screen, but some borders of the image will
be cropped. The aspect ratio is preserved.
[Full Screen]: The image is stretched to fill the screen. The aspect ratio is not preserved.
[Zoom]: The image can be zoomed, cropped and stretched at your convenience.
[Under/over]
Select an item with + ENTER.
[Underscan]: The output image is full screen.
[Overscan]: The output is 10% bigger than in underscan mode.
[RGB Levels] (Available for analog input source only).
Select an item with + ENTER.
[Red]: Adjust the level of the Red with + ENTER.
[Green]: Adjust the level of the Green with + ENTER.
[Blue]: Adjust the level of the Blue with + ENTER.
[Black Level]
Adjust the Black level with + ENTER.