Filter
Top Products
1
At Antec, we continually refine and improve our products to ensure the highest
quality. As such it’s possible that your new case may differ slightly from the
descriptions in this manual. This isn’t a problem; it’s simply an improvement. As
of the date of publication, all features, descriptions, and illustrations in this manual
are correct.
SONATA III 500 USER’S MANUAL
The Sonata III 500 comes with a 500 Watt EarthWatts™ power supply unit (PSU)
which is built to be compatible with the ATX12V version 2.2 specification. This
PSU features higher energy efficiency which reduces power consumption by up to
25%, saving you money on your electricity bill. EarthWatts power supplies have
achieved 80 PLUS® Certification, the latest independent standard in power supply
efficiency. In addition EarthWatts includes a variety of protective circuitry:
OPP (over power protection), OVP (Over Voltage Protection), and SCP (Short
Circuit Protection).
EarthWatts also includes Universal Input with Active Power Factor Correction
(PFC). Universal Input allows you to connect your Antec EarthWatts power supply
to any AC power outlet between 100~240V without having to worry about setting
a voltage switch. Active PFC reduces electrical waste by improving the power factor
value to the power supply, helping the power plant to provide power to users
more efficiently.
Power Switch: This power supply comes with a main power switch. Make sure
you turn the switch to the ON (I) position before you boot up your computer for
the first time. In normal operation there is no need to turn the switch to the OFF
(O) position since the power supply is equipped with a soft on/off feature, which
turns your computer on and off through the soft switch on your computer case.
You may need to turn the switch to the OFF position occasionally should your
computer crash and you cannot shut it down through use of the soft switch.
SETTING UP
Place the case upright on a flat, stable surface. The power supply fan should be
at the back, facing you. Remove the thumbscrews from the panel with the latch.
Unlock the side panel, swing the panel out, and remove it. Set the panel safely
aside.
Note: Please do not try to use your fingernails to pry or lift the panel. Inside the
case you should see the power supply, a 120mm TriCool™ fan (preinstalled), some
wiring with marked connectors (USB, PWR etc.), an installed I/O panel, and a
power cord. You will also find a bag of hardware (screws, brass standoffs,
plastic stands, etc.)
Disclaimer
This manual is intended only as a guide for Antec’s Computer Enclosures. For more
comprehensive instructions on installing the motherboard and peripherals, please
refer to the user’s manuals that come with those components.