Filter
Top Products
8
3. Slide the device into the drive bay until you hear a click.
4. Mount the other devices accordingly.
5. Connect a large 4-pin connector from the power supply to the male 4-pin connector on each
of the devices.
To install a floppy or other external 3.5" device to the 5.25" to 3.5" adapter:
1. Slide the adapter out.
2. Place the drive to the adapter and fasten the drive with screws provided.
3. Find a 4-pin floppy power connector on the power supply and connect it to the male 4-pin
connector on the devices.
Cable Organizer
There are six hooks (cable organizers) located at the back of the hard drive cage. With them
you can tuck cables away to increase the airflow of the case. To get to the cable organizer you
need to open the right side panel.
Cooling System
The TriCool fan:
The case includes one 120mm TriCool fan installed in the rear. This fan has a three-speed switch
that lets you choose between quiet, performance, or maximum cooling. (See specifications
below.) The fan is installed so that the air is blowing out of the case. Connect a large 4-pin
connector from the power supply to the male 4-pin connector on the fan.
Note: The minimum voltage to start the fan is 5V. We recommend setting the fan speed to
High if you choose to connect the fan to a fan control device or to the Fan-Only connector
found on some of Antec's power supplies. A fan-controlled device regulates the fan speed by
varying the voltage supplied to it. The voltage may start as low as 4.5 V to 5V. Connecting a
TriCool set on Medium or Low to a fan-control device may result in the fan not being able to
start. The already lowered voltage from the fan control device will be further reduced by the
TriCool circuitry below 5V.
Specifications:
Size: 120 x 120 x 25.4 mm
Rated Voltage: DC 12V
Operating Voltage: 10.2V ~ 13.8V
The Front 92 mm Fan Mounts
You can install two 92 mm fans to the fan cage in front of the internal 3.5" drives. These fans
must be installed so that the air is blowing into the case. We recommend using Antec 92 mm
TriCool fans to balance quiet performance with maximum cooling. See our web site for product
information. Note: Please choose your fan speed wisely. In most cases, a medium or even low
speed setting will be enough to supply adequate cooling.
Static
Pressure
2.54 mm-H2O
(0.10 inch-H2O)
Speed
Input
Current
Air Flow
Acoustical
Noise
Input
Power
High
2000 RPM
0.24A
(Max.)
2.24 m³/min.
(79 CFM)
30 dBA 2.9 W
Medium
1600 RPM
Low
1200 RPM
0.2A
0.13A
1.59 m³/min.
(56 CFM)
1.1 m³/min.
(39 CFM)
1.53 mm-H
2O
(0.06 inch-H2O)
0.92 mm-H
2O
(0.04 inch-H2O)
28 dBA
25 dBA
2.4 W
1.6 W