Filter
Top Products
15
4.2
O
PTIONAL
F
ANS
There are two optional 120 mm front intake fan mounts at the front of the HDD cage. We recommend using Antec 120
mm speed control fans and setting the speed to Low. These fans must be installed so that the air is blowing into the
case.
Front Fans
– You can install two 120 mm fans to the fan cages in front of the hard drive bays. To install the front fans:
1.
Remove the front bezel as described in section 2.5
2.
Secure your 120 mm fan(s) to the fan holder. The fan should be installed so that air is blowing into the case.
3.
Reattach the fan holder to the case by inserting the right side into the corresponding slots on the front of the
case, then rotating the holder back into position until it clicks into place.