Antex electronic SX-36 Network Card User Manual


 
53
SX-34:
THD+N........................................................................... .02% max
Dynamic Range...............................................................80dB min
Line Out level ....................................................................1V RMS
Line Out load impedance (90Hz to 20KHz, -3dB) .........8 ohms min
Line Out load impedance (20 Hz to 20 KHz).............. 2K ohms min
Line In/ Aux In level ...........................................................1V RMS
Line In/ Aux In input impedance......................................10K ohms
DSP...............................................................TMS320C32, 50MHz
Note that the Line Out will drive headphones, but the low fre-
quency response will begin rolling off at approximately 90Hz.
SX-6:
THD+N........................................................................... .02% max
Dynamic Range...............................................................85dB min
Balanced Output level, low trim ............................................+8dBu
Balanced Output level, high trim.........................................+20dBu
Balanced Output impedance (each leg)............................ 50 ohms
Balanced Output load impedance.............................600 ohms min
Mic feed-through gain.............................................................80dB
DSP..............................................................TMS320C31, 40 MHz