APC ACRC500 Power Supply User Manual


 
InRow RC/RD/RP (600 mm) User’s Guide28
Settings
Leave the Syslog settings, except the Server IP settings, set to their defaults unless otherwise specified
by the Syslog network or system administrator.
Setting Definition
Message
Generation
Enables (by default) or disables the Syslog feature.
Facility Code Selects the facility code assigned to the cooling unit’s Syslog messages (User, by
default).
Note: User is the selection that best defines the Syslog messages sent by the cooling
unit. Do not change this selection unless advised to do so by the Syslog network or
system administrator.
Severity
Mapping
Maps each of the severity levels assigned to cooling unit
events to the available Syslog
priorities. You should not need to change the default mappings.
The following definitions are from RFC3164:
Emergency: The system is unusable
Alert: Action must be taken immediately
Critical: Critical conditions
Error: Error conditions
Warning: Warning conditions
Notice: Normal but significant conditions
Informational: Informational messages
Debug: Debug-level messages
Following are the default settings for the four Local Priority settings:
Critical is mapped to Critical
Warning is mapped to Warning
Informational is mapped to Info
Note: To disable sending Syslog messages for Critical, Warning, or
Informational events, see “Configuring event actions” on page 49.