Filter
Top Products
51InRow RC/RD/RP (600 mm) User’s Guide
Configuring by group. To configure a group of events simultaneously:
1. Select the Administration tab, Notification on the top menu bar, and by group under Event
Actions on the left navigation menu.
2. Choose how you want events to be grouped for configuration and select Next:
– If you choose Events by severity, you can then select all events of one or more severity types.
– If you choose Events by category, you can then select all events in one or more predefined
categories.
3. Select event actions for all events in the group.
– Click the Logging button to choose logging for all events in the group. Click Next>>, and then
mark the checkboxes to enable (or clear them to disable) event logging or Syslog for these
events.
– Click the E-mail Recipients or Trap Receivers button, click Next>>, and select an e-mail
recipient or trap receiver. Then specify any value up to three digits to configure the
following detailed options:
• How long, in seconds or minutes, the cooling unit waits after one of these events occurs
before sending e-mail to the selected e-mail recipient or a trap to the selected trap receiver.
If the event clears during this delay period, no notification is sent. To configure a delay
longer than 999 seconds (16 minutes, 39 seconds), use minutes.
• How frequently to send e-mail to the selected e-mail recipient or a trap to the selected trap
receiver. E-mail or a trap repeats at the time interval specified here in seconds, minutes, or
hours, unless the event has cleared.
• The number of times to send e-mail to the selected e-mail recipient or a trap to the selected
trap receiver. Choose to send e-mail or a trap a specified number of times or to repeat the
notification an unlimited number of times. In either case, notification stops if the event
clears.
4. Click Next>>, and then click Apply to confirm the displayed selections.
5. Click Finish to return to the by group page, or select Configure Additional Actions to keep the
selected event group and to configure the remaining Logging, E-mail Recipients, or Trap
Receivers actions for this group.
Note: When configuring events by severity, you must use their existing severity.
You cannot change the severity of an event.
Note: A Syslog server must be configured in order to display or use the Syslog
option, and at least one e-mail recipient (for e-mail notification) or at least one trap
receiver (for notification by SNMP traps) must be configured in order to display the
detailed e-mail and trap receiver notification options.
To add or remove recipients or receivers, see “E-mail recipients” on page 53 or
“Trap receivers.” on page 54