Filter
Top Products
Environmental Manager: Main Module
11
To install a sensor on the door of an APC
rack:
1. For optimal sensor performance, install the
sensor near the top of the rack door. The
bottom of the rack door will not accurately
represent the temperature of the air in the
room.
2. Thread a tie wrap through the door holes,
skipping one hole in the middle.
–If you have a temperature/humidity sensor,
place the sensor in the middle of the tie
wrap, and pull the tie wrap around a ridge
on the sensor casing.
–If you have a temperature sensor, pull the tie
wrap around the sensor cord, about 1/2-in
(1 1/4-cm) from the sensor.
3. Tighten and trim the tie wrap.
4. To route the sensor cord, choose a location on
the inside of the door frame that is even with
the sensor.
5. Peel the backing off the adhesive side of a
cable mount, and press the cable mount firmly
to the inside of the door frame. Thread a tie
wrap through the cable mount, and secure the
sensor cord with the tie wrap. Tighten and trim
the tie wrap.
aem0073a
aem0074a