Filter
Top Products
Installation Manual
5
Step 2: Install the Network Management Card
The Network Management Card is sensitive to static electricity.
When handling the Network Management Card, touch only the
end plate while using one or more of these electrostatic-discharge
devices (ESDs): wrist straps, heel straps, toe straps, or conductive
shoes.
For the location of the UPS card slot, see the UPS documentation.
1. Locate the UPS card slot.
2. Use the same screws that hold the slot cover in place to secure the
Network Management Card in the UPS card slot.
3. Connect a network interface cable to the 10/100Base-T network
connector
on the Network Management Card.
Step 3: Restore power to the card slot
To restore power to the card slot and energize the Network Management Card,
reconnect the UPS to its input power source and then turn on the UPS
Step 4: Configure the Network Management Card
See “Quick Configuration” on page 8.