Filter
Top Products
iv
Class B Labeling and
Instruction Manual Requirements
Devices subject to Certification must be labeled with an FCC Identifier.
Devices subject to Verification or Certification must be labeled with the
following compliance statement:
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
In addition, for a Class B digital device or peripheral, the instructions
furnished the user shall include the following or similar statement, placed in a
prominent location in the text of the manual:
Warning
: Changes or modifications to this unit not expressly
approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
NOTE
: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the
CC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiated
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and
receiver.
– Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
– Consult the dealer or an experienced audio TV technician
for help.
If shielded cables or other specialized accessories are necessary for the unit
to achieve compliance, a statement similar to the following should be added:
Shielded cables must be used with this unit to ensure compliance
with the Class B FCC limits.