Filter
Top Products
14 Metered Rack Power Distribution Unit
Control console
After you log on at the control console, as
described in “Local access to the control console”
on page 12 or “Remote access to the control
console” on page 13:
1. Choose Network from the Control Console
menu.
2. Choose TCP/IP
from the Network menu.
3. If you are not using a BOOTP or DHCP server
to configure the TCP/IP settings, select the
Boot Mode menu. Select Manual boot mode,
and then press
ESC to return to the TCP/IP
menu. Set the System
IP, Subnet Mask, and
Default Gateway address values.(Changes
will take effect when you log off.)
4. Press
CTRL+C to exit to the Control Console
menu.
5. Log off (option 4 in the Control Console
menu).
Note
If you disconnected a cable during the
procedure described in “Local access
to the control console” on page 12,
reconnect that cable and restart the
associated service.