Filter
Top Products
Smart-UPS C 1000/1500/2000/3000 VA 120/230 Vac Rack-Mount 2U10
Function Options Description
Self-Test • 0: Default Setting
• 1: Begin Self-Test
When set to 1, pressing the
DISPLAY button will trigger the
self test and exit the Configuration Mode.
0 is the default setting and will not initiate a self test, by
pressing the
DISPLAY button you will advance to the next
configuration item.
Note: When the UPS is in Configuration mode
and the UPS output power is off, a Self-Test
cannot be initiated.
Sensitivity
Setting
•High
•Medium
•Low
Select the Sensitivity range depending on the desired
quality of input AC power:
• If High is selected, the unit will go on battery power more
often to provide the cleanest power supply to the
connected equipment.
• If Medium is selected, the UPS is under normal operating
conditions.
• If Low is selected, the UPS will tolerate more fluctuations
in power and will go on battery power less often.
If unsure of the local power quality, select Low.
Output
Voltage
Setting
*
230V models only
•220 Vac
•230 Vac
•240 Vac
Select the appropriate voltage of outlets when the UPS is in
Standby mode.
LCD Display
Dimmer
• Load Bar Icon
shows 100% =
Always On.
• Load Bar Icon
shows 0% = Auto
Dim.
When the LCD Display Dimmer is configured to Auto Dim
the LCD will illuminate if a button is pressed or an event
occurs, then will automatically dim after 60 seconds of no
activity.
Green Mode
Enable
• 0: Disable
• 1: Enable
When Green Mode is enabled the UPS is operating at the
most efficient level by bypassing unused AVR components
while acceptable AC voltage is present. The UPS will enter
and exit Green mode automatically while Enabled.
Clear Event
Counter
•NA
Pressing the
MUTE button will clear the event counter.