Filter
Top Products
6
Putting batteries into the remote control
WARNING ►Always handle the batteries with care and use them only as
directed. Improper use may result in battery explosion, cracking or leakage,
which could result in fire, injury and/or pollution of the surrounding environment.
• Be sure to use only the batteries specified. Do not use batteries of different
types at the same time. Do not mix a new battery with used one.
• Make sure the plus and minus terminals are correctly aligned when loading a
battery.
• Keep a battery away from children and pets.
• Do not recharge, short circuit, solder or disassemble a battery.
•
Do not allow a battery in a fire or water. Keep batteries in a dark, cool and dry place.
•
If you observe a leakage of a battery, wipe out the flower and then replace a battery.
If the liquid adheres to your body or clothes, rinse well with water immediately.
1.
Remove the battery cover.
Slide back and remove the battery cover in the direction of
the arrow.
2.
I
nsert the batteries.
Align and insert the two AA batteries according to their plus
and minus terminals as indicated in the remote control.
3.
Close the battery cover.
Replace the battery cover in the direction of the arrow and
snap it back into place.
Putting batteries into the remote control / Connecting the power supply
Connecting the power supply
WARNING ►Please use extra caution when connecting the power cord, as
incorrect or faulty connections may result in fire and/or electrical shock.
• Only use the power cord that came with the projector. If it is damaged, contact
your dealer to newly get correct one.
• Only plug the power cord into an outlet rated for use with the power cord's
specified voltage range.
• Never modify the power cord. Never attempt to defeat the ground connection of
the three-pronged plug.
1.
Connect the connector of the power cord
to the AC inlet of the projector.
2.
Firmly plug the power cord's plug into
the outlet.
AC inlet
Connector
of the power cord