Filter
Top Products
10
Displaying a video image
Remove the lens cap.
Press the Power button on the top of the projector or the remote.
The Power light on the Status Indicator Panel (page 12) blinks green and the
fans start to run. When the lamp comes on, the start up screen displays and
the Power light is steady green. It can take a minute for the image to achieve
full brightness.
.
? No startup screen? Get help on page 12.
Plug in and turn on the video device.
The video device’s image should appear on the projection screen. If it
doesn’t, press the Source button on the keypad.
Adjust the height of the projector by pressing the release button to extend
the elevator foot. Rotate the leveling foot, if necessary.
Position the projector the desired distance from the screen, so that the lens is
perpendicular to the screen. See page 36 for a table listing screen sizes and
distances to the screen.
remove lens cap
press Power button
turn on video device
adjust height
rotate
leveling
foot
elevator
foot
release button
adjust distance