Filter
Top Products
Chapter 3 54
Removing the LCD Module
Removing the Middle Cover
1. See “Removing the Battery” on page 50.
2. To remove the middle cover, first use a plastic flat screwdriver to detach the right hinge cap. If you do not
have a plastic flat screwdriver, you can simply detach the right hinge cover as the image shows. There is
no screw fastening the right hinge cap to the main unit. Please just detach it.
3. Detach the left hinge cap.
4. Remove the two screws holding the middle cover.
5. Then detach the middle cover from the machine.
6. Turn over the middle cover then disconnect the launch board cable. Then remove the middle cover.
Removing the Launch Board
1. See “Removing the Battery” on page 50.
2. See “Removing the Middle Cover” on page 54.
3. Remove the two screws that secure the launch board to the middle cover. Then detach the launch board
from the middle cover.