Asus A7V Computer Hardware User Manual


 
ASUS A7V Users Manual 61
4. BIOS SETUP
4. BIOS SETUP
Advanced Menu
System Performance Setting [Optimal]
This function controls settings related to system memory performance. When
[Optimal] is selected, DRAM bank interleave, 4k page, and burst refresh
will be enabled to boost system performance. For more system stability,
select [Normal]. Configuration options: [Optimal] [Normal]
CPU Vcore Setting [Auto]
In JumperFree mode, this field allows you to select the core voltage supplied
to the CPU. Leave on [Auto] to use the CPU default setting. If you want to set
it manually, select [User Define], go to the subsequent CPU Vcore field, and
refer to your CPU documentation to make the configuration.
CPU Level 1 Cache, CPU Level 2 Cache [Enabled]
These fields allow you to choose from the default of [Enabled] or choose
[Disabled] to turn on or off the CPUs Level 1 and Level 2 built-in cache.
Configuration options: [Disabled] [Enabled]
CPU Level 2 Cache ECC Check [Disabled]
This function controls the ECC capability in the CPU level 2 cache. Con-
figuration options: [Disabled] [Enabled]
BIOS Update [Enabled]
This functions as an update loader integrated into the BIOS to supply the
processor with the required data. In the default position of [Enabled], the
BIOS will load the update on all processors during system bootup. Configu-
ration options: [Disabled] [Enabled]
PS/2 Mouse Function Control [Auto]
The default of [Auto] allows the system to detect a PS/2 mouse on startup.
If detected, IRQ12 will be used for the PS/2 mouse. IRQ12 will be reserved
for expansion cards only if a PS/2 mouse is not detected. [Enabled] will
always reserve IRQ12, whether on startup a PS/2 mouse is detected or not.
Configuration options: [Enabled] [Auto]
USB Legacy Support [Auto]
This motherboard supports Universal Serial Bus (USB) devices. The de-
fault of [Auto] allows the system to detect a USB device on startup. If de-
tected, the USB controller will be enabled. If not detected, the USB control-
ler will be disabled. When this field is set to [Disabled], the USB controller
is disabled no matter whether you are using a USB device or not. Configu-
ration options: [Disabled] [Enabled] [Auto]
OS/2 Onboard Memory > 64M [Disabled]
When using OS/2 operating systems with installed DRAM of greater than
64MB, you need to set this option to [Enabled]; otherwise, leave this on
[Disabled]. Configuration options: [Disabled] [Enabled]