Filter
Top Products
User’s Manual 2-3
2.1.2 Installing the cover
1. Match and insert the hooks of the cover to the elongated holes on the
side of the chassis. All the six hook (three each on the top and bottom)
of the cover must properly fit the designated holes.
2. Slide the chassis cover for about half an inch towards the front until it
snaps in place.
3. Tighten the thumb screws to secure the cover.
There are six (6) chassis guide hooks located on the upper
side and lower side of the chassis cover, make sure all six
are aligned properly in place.
1
2
3