Filter
Top Products
22 ASUS P2B User’s Manual
CPU
III. INSTALLATION
III. INSTALLATION
ASUS Smart Thermal Solutions
ASUS provides two smart solutions to Slot 1 CPU thermal problems: the ASUS
Smart Fan or ASUS S-P2FAN and the ASUS P2T-Cable.
ASUS S-P2FAN
The optional ASUS Smart Fan or
ASUS S-P2FAN is a CPU fan for a
Pentium
®
II processor packaged in
an SECC. Unlike other CPU thermal
solutions, the ASUS S-P2FAN has
an integrated thermal sensor located near the center of the CPU heat source. The
sensor is optimized by ASUS to give the most accurate reading of the CPU tempera-
ture, thus provides the best protection to your computer system.
To Use the ASUS S-P2FAN
See 2. Attach the Heatsink on the preceding page for the relevant procedures. Note
that the S-P2FAN comes with a rock arm design for easy FAN/CPU installation.
1. Simply peel off the tab from the sensor and then stick the sensor near the middle
edge of the Intel boxed processor heatsink with fan (middle) or to either the
upper or lower edge of the Celeron™ heatsink (right), as indicated.
To Use the ASUS P2T-Cable
NOTE: The following procedures assume that you have properly attached a
heatsink onto an SECC/SECC2/SEPP.
ASUS P2T-Cable
The optional ASUS P2T-Cable can be
used for a Pentium
®
II processor pack-
aged in an SECC/SECC2 or a
Celeron™ processor packaged in an
SEPP .
NOTE: The ASUS P2T-Cable can only be used in a Slot 1 motherboard with a
2-pin thermal sensor connector.
Sensor Connector Plug
Rock Arm
CPU Fan Cable
Thermal Sensor
Cable
Sensor