Filter
Top Products
1-13 Chapter 1: Product introduction
2. Serial ATA connectors (7-pin SATA1, SATA2)
These connectors are for the Serial ATA signal cables for Serial ATA 3Gb/s hard disk
drives and optical disk drives. The Serial ATA 3Gb/s is backward compatible with the
Serial ATA 1.5Gb/s specication. The data transfer rate of the Serial ATA 3Gb/s is faster
than the standard parallel ATA (133 MB/s).
Install the Windows
®
XP Service Pack 2 or later versions before using Serial ATA.
3. USB connector (10-1 pin USB56, USB78)
These connectors are for USB 2.0 ports. Connect the USB module cable to this
connector, then install the module to a slot opening at the back of the system chassis.
This USB connector complys with USB 2.0 specication that supports up to 480 Mbps
connection speed.
Never connect a 1394 cable to the USB connector. Doing so will damage the motherboard!
The USB module cable is purchased separately.
E5179_AT5NM10-I.indb 13 12/22/09 5:56:01 PM