Filter
Top Products
18 ASUS C-P55T2D User’s Manual
PCI/VGA Palette Snoop
Some display cards that are nonstandard VGA such as graphics accelerators or MPEG
Video Cards may not show colors properly. The setting Enabled should correct this
problem. Otherwise leave this on the setup default setting of Disabled.
OS/2 Onboard Memory > 64M
When using OS/2 operating systems with installed DRAM of greater than 64MB,
you need to Enable this option otherwise leave this on the setup default of Disabled.
MPS 1.4 Support
MPS 1.4 is Intel’s Multi-Processor Specification. Some MP operating systems still
cannot support it. If your MP operating system cannot support MPS 1.4, you must
leave this feature on the default of Disabled.
......................................................................................................................................
Video ROM BIOS Shadow
This field allows you to change the video BIOS location from ROM to RAM. Relo-
cating to RAM enhances system performance because information access is faster
than to ROM. Setup default setting is Enabled.
C8000 – CBFFF Shadow to DC000 – DFFFF Shadow
These fields are used for shadowing other expansion card ROMs. If you install
other expansion cards with ROMs on them, you will need to know which addresses
the ROMs use to shadow them specifically. Shadowing a ROM reduces the memory
available between 640KB and 1024KB by the amount used for this purpose. Leave
on default setting of Disabled.
......................................................................................................................................
Boot Up NumLock Status
This field enables users to activate the Number Lock function upon system boot.
The setup default setting for this field is On.
Boot Up System Speed
This has no function and should be left at the setup default of High.
Typematic Rate Setting
When enabled, you can set the two typematic controls listed below. Setup default
setting is Disabled.
Typematic Rate (Chars/Sec)
This field controls the speed at which the system registers repeated keystrokes.
Options range from 6 to 30 characters per second. Setup default setting is 6; other
settings are 8, 10, 12, 15, 20, 24, and 30.
Typematic Delay (Msec)
This field sets the time interval, in milliseconds, for displaying the first and second
characters. Four delay rate options are available: 250 (default), 500, 750 and 1000.
IV. BIOS SOFTWARE
IV. BIOS
(BIOS Features)