Filter
Top Products
ASUS M3A32-MVP Deluxe Series 5-43
5.4.4 Marvell
®
RAID congurations
The Marvell
®
6121 Serial ATA controller allows you to congure RAID 0 and RAID 1
sets on the Serial ATA hard disk drives.
Setting the RAID item in BIOS
You must set the RAID item in the BIOS Setup before you can create a RAID
set(s). To do this:
1. Install two internal Serial ATA hard disk drives to the SATA connectors labeled
SATA_RAID1/2
.
2. Boot up your computer, and press <Del> during POST to enter the BIOS
setup.
3. In the Advanced Menu, go to
Onboard Devices Conguration
, and enable
both
Marvell 6121 SATA Controller
and
Marvell Option ROM
.
4. Set
Marvell IDE/RAID function
to [RAID].
Select Screen
Select Item
+- Change Option
F1 General Help
F10 Save and Exit
ESC Exit
v02.61 (C)Copyright 1985-2007, American Megatrends, Inc.
Onboard Devices Conguraiton
Serial Port1 Address [3F8/IRQ4]
Serial Port1 Mode [Normal]
HD Audio Azalia Device [Auto]
Front Panel support Type [HD Audio]
Onboard Lan [Enable]
Onboard Lan Boot Rom [Disabled]
Marvell 6111 SATA Controller [Enable]
Marvell 6121 SATA Controller [Enable]
Marvell Option ROM [Enable]
Marvell IDE/RAID function [RAID]
Primary Display Adapter [PCI-E]
Allows BIOS to select
Serial Port1 Base
Addresses.
BIOS SETUP UTILITY
Advanced
3. Press <F10> to save the changes and exit.
The RAID BIOS setup screens shown in this section are for reference only, and
may not exactly match the items on your screen.