Asus NCL-DR1 Personal Computer User Manual


 
4-164-16
4-164-16
4-16
Chapter 4: BIOS setupChapter 4: BIOS setup
Chapter 4: BIOS setupChapter 4: BIOS setup
Chapter 4: BIOS setup
Onboard IDE Operate Mode [Enhanced Mode]Onboard IDE Operate Mode [Enhanced Mode]
Onboard IDE Operate Mode [Enhanced Mode]Onboard IDE Operate Mode [Enhanced Mode]
Onboard IDE Operate Mode [Enhanced Mode]
Allows selection of the IDE operation mode depending on the installed
operating system (OS). Set to [Enhanced Mode] if you are using native OS,
e.g. Windows
®
2000/XP. Set to [Compatible Mode] if you are using legacy
OS, e.g. Windows ME/98/NT, MS-DOS.
Configuration options: [Compatible Mode] [Enhanced Mode]
IDE Configuration
Onboard IDE Operate Mode [Enhanced Mode]
Enhanced Mode Support On [S-ATA]
Configure S-ATA as RAID [No]
IDE Detect Time Out (Sec) [35]
When in AHCI/RAID
mode SATA
controller is
forced to Native
mode.
4.3.54.3.5
4.3.54.3.5
4.3.5
IDE ConfigurationIDE Configuration
IDE ConfigurationIDE Configuration
IDE Configuration
The items in this menu allow you to set or change the configurations for
the IDE devices installed in the system. Select an item then press <Enter>
if you wish to configure the item.
The items
Enhanced Mode Support OnEnhanced Mode Support On
Enhanced Mode Support OnEnhanced Mode Support On
Enhanced Mode Support On and
Configure S-ATAConfigure S-ATA
Configure S-ATAConfigure S-ATA
Configure S-ATA
as RAIDas RAID
as RAIDas RAID
as RAID appear only when you set the Onboard IDE Operate Mode to
[Enhanced Mode].
Enhanced Mode Support On [S-ATA]
Allows you to set Serial ATA, Parallel ATA, or both, to native mode.
Configuration options: [P-ATA+S-ATA] [S-ATA] [ P-ATA]
Configure S-ATA as RAID [No]Configure S-ATA as RAID [No]
Configure S-ATA as RAID [No]Configure S-ATA as RAID [No]
Configure S-ATA as RAID [No]
Allows you to configure the Serial ATA devices as RAID sets.
Configuration options: [No] [Yes]
IDE Detect Time Out (Sec) [35]IDE Detect Time Out (Sec) [35]
IDE Detect Time Out (Sec) [35]IDE Detect Time Out (Sec) [35]
IDE Detect Time Out (Sec) [35]
Selects the time our value (in seconds) for detecting ATA/ATAPI devices.
Configuration options: [0] [5] [10] [15] [20] [25] [30] [35]