Filter
Top Products
4-6
Chapter 4: BIOS Setup
To recover the BIOS from the support CD:
1. Boot the system.
2. When a corrupted BIOS is detected, the following screen message
appears.
3. Place the support CD in the CD-ROM. The support CD contains the
original BIOS for this motherboard.
If there is no floppy disk found in the drive, the system automatically
checks the CD-ROM.
3. Insert a floppy disk that contains the original or the latest BIOS file for
this motherboard. If all the necessary files are found in the floppy disk,
the BIOS update process continues.
4. When the BIOS update process is complete, reboot the system.
Make sure that the BIOS file in the floppy disk is renamed as
“P4P800SE.ROM”.
DO NOT shutdown or reset the system while updating the BIOS! Doing
so may cause system boot failure!
Bad BIOS checksum. Starting BIOS recovery...
Checking for floppy...
Floppy not found!
Checking for CD-ROM...
CD-ROM found.
Reading file “P4P800SE.ROM”. Completed.
Start flashing...
Bad BIOS checksum. Starting BIOS recovery...
Checking for floppy...
Floppy found!
Reading file “P4P800SE.ROM”. Completed.
Start flashing...
Bad BIOS checksum. Starting BIOS recovery...
Checking for floppy...