Filter
Top Products
ASUS P5A-VM User’s Manual 53
IV. BIOS SOFTWARE
IV. BIOS
Load Setup Defaults
IV. BIOS
Plug & Play/PCI
DMA x Used By ISA (No/ICU)
These fields indicate whether or not the displayed DMA channel for each field is
being used by a legacy (non-PnP) ISA card. Available options include: No/ICU and
Yes. The first option, the default setting, indicates either that the displayed DMA
channel is not used or an ICU is being used to determine if an ISA card is using that
channel. If you install a legacy ISA card that requires a unique DMA channel, and
you are not using an ICU, you must set the field for that channel to Yes.
ISA MEM Block BASE (No/ICU)
This field allows you to set the base address and block size of a legacy ISA card that
uses any memory segment within the C800H and DFFFH address range. If you
have such a card, and you are not using an ICU to specify its address range, select a
base address from the six available options; the ISA MEM Block SIZE field will
then appear for selecting the block size. If you have more than one legacy ISA card
in your system that requires to use this address range, you can increase the block
size to either 8K, 16K, 32K, or 64K. If you are using an ICU to accomplish this task,
leave ISA MEM Block BASE to its default setting of No/ICU.
SYMBIOS SCSI BIOS (Auto)
Auto
allows the motherboard’s BIOS to detect whether you have a Symbios
SCSI card. If a Symbios SCSI card is detected, the motherboard’s Symbios
BIOS will be enabled; if no Symbios SCSI card is detected, the onboard
Symbios SCSI BIOS will be disabled. Disabled will disable the
motherboard’s Symbios SCSI BIOS so that the BIOS on an external Symbios
SCSI card can be used. (If your Symbios SCSI card does not have a BIOS,
the Symbios SCSI card will not function.)
USB Function (Disabled)
This motherboard supports Universal Serial Bus (USB) devices. Set to Enabled if
you want to use USB devices. Your system must support USB function. The default
setting is Disabled.
USB IRQ (Auto)
This field allows you to reserve an IRQ# (5, 7, 9, 10, 11, 12, 14, or 15) for the USB
to work. Auto assigns an IRQ# automatically to your USB device. If you are not
using a USB device, you may disable this feature by setting it to NA to save an extra
IRQ# for other devices or expansion cards.
ONB VGA BIOS First (No)
This field, when set to Ye s, gives priority to the onboard VGA BIOS over other VGA
controllers. The default setting is No.
Onboard Audio (Enabled)
This field allows you to enable the onboard audio. If you do not watn to use the
onboard audio, select Disabled. (This feature is available only on motherboards with
the audio option.)