Filter
Top Products
1-26 Chapter 1: Product introduction
2. Primary IDE connector (40-1 pin PRI_IDE)
These connectors are for Ultra DMA 100/66 signal cables. The Ultra
DMA 100/66 signal cable has three connectors: a blue connector for
the primary IDE connector on the motherboard, a black connector
for an Ultra DMA 100/66 IDE slave device (optical drive/hard disk
drive), and a gray connector for an Ultra DMA 100/66 IDE master
device (hard disk drive). If you install two hard disk drives, you must
congure the second drive as a slave device by setting its jumper
accordingly. Refer to the hard disk documentation for the jumper
settings.
• Pin 20 on the IDE connector is removed to match the covered hole
on the Ultra DMA cable connector. This prevents incorrect insertion
when you connect the IDE cable.
• Use the 80-conductor IDE cable for Ultra DMA 100/66 IDE devices.
®
P5LD2-FM/DH/VP
P5LD2-FM/DH/VP PRI_IDE Connector
NOTE: Orient the red markings
(usually zigzag) on the IDE
cable to PIN 1.
PRI_IDE
PIN1