Filter
Top Products
2-42 Chapter 2: BIOS setup
The items Typematic Rate (Chars/Sec) and Typematic Delay (Msec)
becomes user-congurable only when the item Typematic Rate Setting is
enabled.
Boot Up Floppy Seek [Disabled]
Enable this item to allow the BIOS to check a oppy drive during POST.
Conguration options: [Disabled] [Enabled]
Bootup Num-Lock [On]
Allows you to select the power-on state for the NumLock.
Conguration options: [Off] [On]
Typematic Rate Setting [Disabled]
Allows you to set the keystroke rate. Enable this item to congure the
Typematic Rate (Chars/Sec) and the Typematic Delay (Msec).
Conguration options: [Disabled] [Enabled]
Typematic Rate (Chars/Sec) [6]
Allows you to select the rate at which a character repeats when you hold a
key. Conguration options: [6] [8] [10] [12] [15] [20] [24] [30]
Typematic Delay (Msec) [250]
Allows you to set the delay before keystrokes begin to repeat.
Conguration options: [250] [500] [750] [1000]
OS Select For DRAM > 64MB [Non-OS2]
Allows you to select the OS2 to operate system with greater than 64MB of
RAM on the system. Conguration options: [Non-OS2] [OS2]
Full Screen LOGO [Disabled]
Allows you to enable or disable the full screen logo display feature.
Conguration options: [Disabled] [Enabled]
Make sure that the above item is set to [Enabled] if you want to use the
ASUS MyLogo2™ feature.
Halt On [All Errors]
Allows you to error report type.
Conguration options: [All Errors] [No Errors] [All, But Keyboard]
[All, But Diskette] [All, But Disk/Key]