Asus P7H55 Computer Hardware User Manual


 
ASUS P7H55/USB3 1-19
The DRAM_LED also lights when the DIMM is not properly installed. Turn off the system
and reinstall the DIMM before using the MemOK! function.
Press the MemOK! switch under Windows™ OS environment will reboot the computer
and start memory tuning.
During the tuning process, the system loads and tests failsafe memory settings. It takes
about 30 seconds for the system to test one set of failsafe settings. If the test fails,
the system reboots and test the next set of failsafe settings. The blinking speed of the
DRAM_LED increases, indicating different test processes.
If the installed DIMMs still fail to boot after the whole tuning process, the DRAM_LED
lights continuously. Replace the DIMMs with ones recommended in the Memory QVL
(Qualied Vendors Lists) in this user manual or on the ASUS website at
www.asus.com.
If you turn off the computer and replace DIMMs during the tuning process, the system
continues memory tuning after turning on the computer. To stop memory tuning, turn off
the computer and unplog the power cord for about 5–10 seconds.
If your system fail to boot due to BIOS overclocking, press the MemOK! switch to boot
and load BIOS default settings. A messgae will appear during POST reminding you that
the BIOS has been restored to its default settings.
1.7 Onboard switches
Onboard switch allows you to ne-tune performance when working on a bare or open-
case system. This is ideal for overclockers and gamers who continually change settings to
enhance system performance.
1. MemOK! switch
Installing DIMMs that are incompatible with the motherboard may cause system
boot failure, and the DRAM_LED near the MemOK! switch lights continuously. Press
and hold the MemOK! switch until the DRAM_LED starts blinking to begin automatic
memory compatibility tuning for successful boot.