Filter
Top Products
2-48 Chapter 2: Hardware information
Chapter 2
4. Attach the IO shield onto the chassis and then place the motherboard flat into the
chassis.
5. Fasten the screws onto the motherboard.
6. Locate from the exterior IO area of the chassis the upper connecting jack of the
Bluetooth v3.0 + HS Module and attach the Wi-Fi Ring Moving Antenna. A click can
be heard when the antenna connector is fully inserted. Give a slight pull to make sure
installation is complete.
POWER eSATA 6G
S/PDIF
USB3.0
USB BIOS Flashback
USB3.0
REAR
SPK
CTR
BASS
LINE
IN
KY
FRONTMIC IN
1. For
BT GO!
software details and configuration, please refer to
Section 4.3.8
.
2. Be sure to install the BT3 driver before installing the BT GO! software.