Filter
Top Products
Chapter 4. OSD Operation
27
(Continued from previous page.)
Setting Function
PORT ID
DISPLAY
MODE
Selects how the Port ID is displayed: the Port Number alone
(PORT NUMBER); the Port Name alone (PORT NAME); or the
Port Number plus the Port Name (PORT NUMBER + PORT
NAME). The default is PORT NUMBER + PORT NAME).
SCAN
DURATION
Determines how long the focus dwells on each port as it cycles
through the selected ports in Auto Scan Mode (see F7 SCAN,
page 33). Key in a value from 1 - 255 seconds, then press [Enter].
Default is 5 seconds; a setting of 0 disables the Scan function.
SCAN/SKIP
MODE
Selects which computers will be accessed under Skip Mode (see
F5 SKP, page 31), and Auto Scan Mode (see F7 SCAN,page 33.
Choices are:
ALL - All the Ports which have been set Accessible (see SET
ACCESSIBLE PORTS, page 30);
POWERED ON - Only those Ports which have been set Accessible
and are Powered On;
QUICK VIEW - Only those Ports which have been set Accessible
and have been selected as Quick View Ports (see SET QUICK
VIEW PORTS, page 30);
QUICK VIEW + POWERED ON - Only those Ports which have
been set Accessible and have been selected as Quick View Ports
and are Powered On. The default is ALL.
Note: The Quick View choices only show up on the Administrator's
screen, since only he has Quick View setting rights (see SET
QUICK VIEW PORTS, page 30, for details).
SCREEN
BLANKER
If there is no input from the console for the amount of time set with
this function, the screen is blanked. Key in a value from
1–30 minutes, then press [Enter]. A setting of 0 disables this
function. The default is 0 (disabled).
HOTKEY
COMMAND
MODE
Enables / Disables the Hotkey Command function in case a
conflict with programs running on the computers occurs.
acs1208a-1216a.book Page 27 Thursday, January 20, 2011 5:08 PM