Filter
Top Products
POWER ON PROCEDURE
AS/2 Auto Switch
3)
When the ‘READY’ LED turns off, it indicates
Connectors are not properly connected,
Printer(or output device) is not switched on,
Printer is not in ON-LINE status,
or, Printer is out of paper.
If buffer card installed for output ‘READY’ LED reflects buffer readiness.
4)
When the AS/2 is serving a certain input channel, it does not switch to
serve another channel even though the printing gets interrupted by
printer’s power off or printer out of paper, etc.
NOTE:
Only in the Manual Switching Mode user can force the AS/2
to switch to and service another input channel.
3-3 MANUAL SWITCHING MODE
1)
2)
3)
Press the ‘SELECT’ button on the left side of the front panel to see the
corresponding LED comes on and the selected input channel’s LED
remains lit.
Now, the AS/2 is in the Manual Switching Mode. If the manual
selected input channel stays on LED 1, then pressing the ‘SELECT’
button again the AS/2 will switch the input channel to the next channel
LED 2. Pressing the ‘SELECT’ button again, it will switch to the next
channel LED 3, and so on.
If the manual selected input channel stays on LED 4 (or LED
8),
then
pressing the ‘SELECT’ button the AS/2 will enter Auto Switching Mode
and LED
1
-
LED 4 (or LED 8) turned on.
16
User’s Manual