Filter
Top Products
3. Basic Operation
23
Hot Plugging
The CL-1208 / CL-1216 supports hot plugging - components can be removed
and added back into the installation by unplugging their cables from the ports
without the need to shut the unit down. In order for hot plugging to work
properly, however, the procedures described below must be followed:
Switching Station Positions
You can switch station positions by simply unplugging from the old parent and
plugging into a new one. After you do, in order for the OSD menus to
correspond to the change, you must reset the Station IDs in the OSD. See
RESET STATION IDS, p. 37, for details.
Hot Plugging KVM Ports
In order for the OSD menus to correspond to the change, you must manually
reconfigure the OSD to reflect the new Port information. See the F3 SET
(p. 32) and F4 ADM (p. 34), functions for details.
Note: If the computer's Operating System does not support hot plugging, this
function may not work properly.
cl12816_v2.book Page 23 Thursday, March 23, 2006 2:21 PM