Filter
Top Products
Changing the Scan Interval
Before you invoke Auto Scan, you can change the amount of
time that Auto Scan dwells on each port (the time interval), with
the following hotkey combination:
[Left shift] [Right shift] [S] [n]
Where n represents a number from 1 to 4 that specifies the
desired scan interval time, as shown in the table below;
n Scan Interval
1
3 secs
2
5 secs
3
10 secs
4
20 secs
Note: Press and release the keys one at a time.
LED Display Table
Activity Indication
Off Port is not selected.
On (Steady) The computer connected to the LED’s
corresponding port is the one that has the KVM
focus.
Flashing (On and Off equal) The computer connected to the LED’s
corresponding port is the one that has the KVM
focus and is being accessed in Auto Scan mode.
- 8 -
2003-06-20