Filter
Top Products
eco PDU PE Series User Manual
33
Installation
To set up your installation, refer to the installation diagram on the next page
(the numbers in the diagram correspond to the numbered steps), and do the
following:
1. Ensure that the eco PDU unit is properly grounded.
Note: Do not omit this step. Proper grounding helps to prevent damage to
the unit from surges of static or electricity.
2. For each device you want to connect, use its power cable to connect from
the device's AC socket to any available outlet on the eco PDU. Use ATEN
Lok-U-Plug cable holders to secure them.
Note: See Securing the Cables, page 35, for details.
3. Plug the cable that connects the eco PDU to the LAN into the eco PDU's
LAN port.
4. (Optional) If you are using environmental sensors in your eco PDU
installation, connect up to four to the RJ-11 sensor ports on the unit’s front
panel.
Note: Sensors are optional. Please see Optional Accessories, page 9, and
the installation diagrams later in this chapter for further information.
5. (Optional) If you are using a door sensor in your eco PDU installation,
connect it to the 4-pin dry sensor port on the unit’s front panel.
Note: See Door Sensor, page 9, for further information.
6. Depending on your model, connect the eco PDU's built-in power cord to
an AC power source, or use the power cord provided to connect the eco
PDU’s power socket to an AC power source.
Once you have finished these installation steps, you can turn on the eco PDU
and the connected devices.