Filter
Top Products
OnePower UPS 600VA/300W(EN)
A03-PE601 Pag. 18
1.6 Operation Test
1. Connect the UPS to the wall receptacle.
2. Push on the Main Switch till the Green LED (
) is extinguished, release
the Main Switch, then the UPS self-test is being performed. The UPS is in
normal status, and the Green LED (
) is ON.
3. Connect your computer equipment with sockets of the UPS and pull off
the input power cable of the UPS from the wall receptacle to check if the
Line (
) LED is flashing every 2 seconds. Meanwhile, please check if
alarm buzzer is beeping.
4. Try the field working condition by running some application programs on
your computer and repeating step.
5. Check if the UPS is initiated properly to support continuous operation. Re-
connect the input power cable to the wall receptacle; the UPS will return
to normal status in a few seconds.
IMPORTANT NOTICE: Plug the UPS into the wall outlet to charge the UPS for
over 10 hours before using the UPS.
1.7 Front Panel Explanations
On the front panel You can found 1 LED for an easy diagnostic.