Filter
Top Products
OnePower UPS 600VA/300W(EN)
A03-PE601 Pag. 21
1. Use a cross-type screwdriver to remove the two screws and slide down the
panel.
2. Gently Pull the battery out of the UPS.
3. Loosen the black wire from the negative (-) terminal and red wire from the
positive (+) terminal.
4. Connect the battery leads to the new battery (small sparks at the battery
connectors are normal during connection).
5. Slide the battery into the UPS.
6. Close the front panel and fasten two screws.
7. Dispose of the old battery properly at an appropriate recycling facility.
NOTE: Once the battery is disconnected, the loads are not protected from power
outages.