Filter
Top Products
ENGLISH
DiskMaster 39
2
RESET
After the device has turned on (turn on the
power and wait 3 minutes), press and hold
reset button for 5 seconds, then release it
to reset it (this is used when you can not
login to the DiskMaster, e.g. forgot the
password.
3
LAN(RJ45)
Please use the Ethernet cable to connect
the DiskMaster to network.
4
USB(V1.1)
Please use the USB printer cable to
connect the device’s USB port (fro printe
server).
5
POWER (jack)
Connect the supplied power adapter to
this jack.
6
POWER(ON/OFF)
Press the power switch to start/shutdown
the DiskMaster. It will take approximately 3
minutes to boot up/and shutdown the
Operating System.
1.7 Default Settings
The TCP/IP protocol stack and Ethernet network adapter must be installed.
If not, please refer to MS Windows relative manuals.
Before you configure this device you need to know the following default
settings:
Username: admin
Password: atlantis
IP address: by DHCP, (If a DHCP server isn’t available in the
network, the DiskMaster will use 192.168.1.1 and Subnet Mask
255.255.255.0).
Server name: DiskMaster