Filter
Top Products
x
FirmwareRestart
Causes the FibreBridge to reboot, then re-initialize its
firmware.Use the
forced
option to override any CLI
reservation held by other sessions.
FirmwareRestart <forced>
Help
Displays a list of available commands. If command name
is specified, displays detailed command-specific
information.
Help [command name]
IdentifyBridge
Enabling this option causes the Ready LED on the
FibreBridge to blink until the parameter is disabled.
set IdentifyBridge [enabled | disabled]
get IdentifyBridge
Info
Displays version numbers and other production
information for key components within the FibreBridge
Info
IPAddress
Controls/displays the current FibreBridge IP address.If
IPDHCP
is enabled,
get
command reports current IP
address assigned by the DHCP server.
Default IP address: 10.0.0.1
set IPAddress [mp1] [xxx.xxx.xxx.xxx]
Requires a SaveConfiguration Restart command
get IPAddress [mp1]
IPDHCP
Selecting DHCP allows the FibreBridge to request an IP
address from the network. The network must have at least
one DHCP server.
Default: enabled
set IPDHCP [mp1] [enabled | disabled]
Requires a SaveConfiguration Restart command
get IPDHCP [mp1]
IPDNSServer
Controls the current DNS Server address. If
IPDHCP
is
enabled, the DNS Server address is automatically
detected. If IPDHCP is disabled, you must set the address
manually using this command.
set IPDNSServer [xxx.xxx.xxx.xxx]
get IPDNSServer
IPGateway
Regulates/displays the current gateway. If
IPDHCP
is
enabled,
get
command reports current IP gateway
assigned by a DHCP server.
Default: 0.0.0.0
set IPGateway [mp1] xxx.xxx.xxx.xxx
Requires a SaveConfiguration Restart command
get IPGateway [mp1]
IPSubnetMask
Regulates/displays the current subnet mask. If
IPDHCP
is enabled,
get
command reports current subnet mask
assigned by DHCP server.
Default: 255.255.0.0
set IPSubnetMask xxx.xxx.xxx.xxx
Requires a SaveConfiguration Restart command
get IPSubnetMask
IsReserved
Displays the reservation status of the current
FibreBridge.
command: IsReserved
LogicalUnitAddressing
Controls the current device mapping method on the
bridge. When disabled, standard peripheral device
mapping and formatting is used. Target devices are only
made visible to the specific mapped Fibre Channel port.
When enabled, static device mapping and formatting is
achieved with a discovery bus scan at boot. All target
devices are visible to all Fibre Channel ports, with each
port sharing a common Fibre Channel Node Name.
Default: disabled
set LogicalUnitAddressing [enabled|disabled]
get LogicalUnitAddressing
MaxOpTemp (FB2390, FB2400 only)
Regulates/displays the maximum enclosure temperature
alarm of the FibreBridge in degrees Celsius. If the
temperature of the FibreBridge rises above the maximum
MaxOpTemp, thermal control event handling
occurs.Valid entries are between 55 degrees and 70
degrees
Default: 70
set MaxOpTemp [55-70]
Requires a SaveConfiguration Restart command
get MaxOpTemp