Filter
Top Products
24
If the devices connected to the Celerity FC host
adapter are not accessible
1 Right-click My Computer.
2Select Properties.
3 Select the Hardware tab.
4Select Device Manager.
• If the Celerity FC host adapter does not appear
under the SCSI and RAID controllers, remove
power from the PC, open the case, and check
that the Celerity FC adapter is properly seated in
the PCI slot. Replace the case and apply power.
• If the adapter has been identified but there is an
exclamation point (!) on the listing, right click on
the listing and select Uninstall.
5 Reload the driver (see Installing and updating
drivers on page 11).
6 Reboot the system and repeat the installation
process.
7 If problems persist, contact your authorized
ATTO Technology representative.
Linux
1Verify the celerityfc driver is loaded with the
lsmod
command. If lsmod does not show the
driver, refer to the installation instructions to
install and load the driver in Installing and
updating drivers on page 11.
2 Check the system log with the command
dmesg
. The celerityfc driver creates status
messages during initialization. Make sure that
all installed cards are properly detected and
initialized.
3 Examine the contents of the file(s)
/proc/scsi/celerityfc/X, where X is the
adapter’s host number. This file contains details
such as link status, connection speed and
discovered devices.
Note
Advanced users only. Modify the
driver
makefile
to enable debugging information.
Upon loading, the
celerityfc driver
displays
detailed debugging information which may
help troubleshoot the problem.