Filter
Top Products
Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, Version 5.3.1 2-39
Initialize and Setup
* Note: If you misconfigure the PPP serial console port, you can
regain CLI access to correct the configuration
parameters. For more information, refer to the “Using
the CLI” section later in this chapter.
Safety Tip: To successfully dial-in with PPP to the switch, you must
also configure an IP address and interface for the PPP
Serial Interface (Serial-Console). Refer to “Managing
Configuration Files”, later in this chapter for more
information.
6. Click APPLY to save your changes, or CANCEL to clear
your selection.
* Note: If you click Apply, the changes are saved in the
Running config only. The Startup config has not
changed. Therefore, these and other changes will be lost
if your switch goes down or if you power it off.
To save these changes, you must copy the Running
config to the Startup config. Refer to the Copying
Configuration Files section later in this section.
Using the CLI To configure the console serial port as a TTY Console using the CLI
after you install a mode, enter the following command in Configure
mode:
>(configure)# set console type {tty|ppp}
Refer to the Command Reference Guide for the Avaya P550R, P580, P880,
and P882 Multiservice Switches, Version 5.3 for details about this
command.
E0 Disable local echo
Software Flow Control
(Receive and
Transmit)
Depends on modem
Table 2-8. Modem Configuration String Parameters
Parameter Definition
2 of 2