Filter
Top Products
Cajun P550/P880/P882 Switch Configuration Guide
Configuring AppleTalk Routing
15-7
Creating an
AppleTalk
Routing
Interface Using
the CLI
To create an AppleTalk interface using the CLI. enter the following
command in Configure mode:
> (config if-:<interface-name>)# appletalk routing
Refer to the Cajun™ P550™/P880/P882 Command Line Interface
Reference Guide for Version 5.0 for details about this command.
Editing AppleTalk Interfaces
You can edit AppleTalk interfaces using either the web agent or the
CLI.
Editing
AppleTalk
Interfaces Using
the Web Agent
To edit an AppleTalk interface using the web agent:
* Note: You must enable AppleTalk globally and create an
AppleTalk interface before you can edit an interface. See
"Enabling AppleTalk Global Routing" and "Creating an
AppleTalk Routing Interface", earlier in this section.
1. Select Interfaces from the Routing > AppleTalk >
Configuration group on the Web Agent window. The
AppleTalk Interfaces dialog box opens (Figure15-2).
2. Select the VLAN to be associated with the interface from the
VLAN field pull-down menu.
3. Enter the new port metric to be associated with the
interface in the Metric field.
4. Select the new frame type to be associated with the
interface from the Frame Type pull-down menu.
5. Enter the new network range start number in the
Network Range Start field.
6. Enter the new network range end number in the
Network Range End field.
7. Enter the new network number to be associated with the
interface in the Network Number field.
8. Enter the new node number to be associated with the
interface in the Node field.
9. Select Enable from the Admin. State field pull-down menu.
10. Select the new default zone associated with the interface
from the Default Zone field pull-down menu.