Filter
Top Products
15-6
Chapter 15
Cajun P550/P880/P882 Switch Configuration Guide
5. Click CREATE to add the new AppleTalk interface, or
CANCEL to restore previous settings.
Network
Range Start
Enter the starting network number. The network
number specifies the range of AppleTalk network
numbers for extended networks. Each number in the
range must be an integer between 0 and 65279.
Note: The Network Range Start value must be less
than or equal to the Network Range End
value.
Network
Range End
Enter the ending network number. The network
number specifies the range of AppleTalk network
numbers for extended networks. Each number in the
range must be an integer between 0 and 65279.
Note: If the Network Range Start value equals 0,
then the Network Range End value must also
equal 0.
Network
Number
Enter the interface network number. This number
specifies the network number the interface is using.
Note: This value must be within the Network Range
or be equal to 0.
Node Enter the interface node identification number. This
number must be between 1 and 253.
Note: Only if the Network Number is equal to 0, can
the Node also be equal to 0.
Admin State Select whether to enable or disable the administrator
state. The administrator state determines if the
interface is operational from a management point of
view.
Zone Select the default AppleTalk zone to be used by this
interface. Zone names may be up to 32 characters in
length.
Table 15-1. Add AppleTalk Interface Dialog Box Parameters
continued
Parameter Definition