Filter
Top Products
15-20
Chapter 15
Cajun P550/P880/P882 Switch Configuration Guide
Editing an AppleTalk Zone Filter
You can edit an AppleTalk zone filter using either the web agent or
the CLI.
Editing an
AppleTalk Zone
Filter Using the
Web Agent
To edit an AppleTalk zone filter using the web agent:
1. Select Zone Filter from the Routing > AppleTalk >
Configuration group on the web agent window. The
AppleTalk Zone Filter dialog box opens (Figure15-12).
2. Click the checkbox in the Select column next to the
AppleTalk zone filter that you want to be edit.
3. Refer to Table15-4 to edit the AppleTalk Zone Filter dialog
box parameters:.
4. Click ...
— CREATE to add a new zone filter. The Add AppleTalk
Zone Filter dialog box opens. See "Creating an
AppleTalk Zone Filter", earlier in this section for more
information.
— DELETE to remove the selected zone filter.
— CANCEL to restore previous settings.
— Edit If to add or delete this zone filter to/from an
interface. The Add/Delete Interface to Zone Filter
dialog box opens. See "Adding or Deleting Interfaces to a
Zone Filter", later in this section for more information.
Editing an
AppleTalk Zone
Filter Using the
CLI
To edit an AppleTalk zone filter using the CLI, enter the following
command from Configure mode:
> (config-if <interface-name>:)# appletalk
access-list <access-list-number>
<permit|deny> zone <string>
Refer to the Cajun™ P550™/P880/P882 Command Line Interface
Reference Guide for Version 5.0 for details about these commands.