Filter
Top Products
8 DSR1024 Switch Installer/User Guide
Connecting the DSR Switch Hardware
To connect and power up your DSR1024 switch:
1. Power down the target device(s) that will be part of your DSR switching system. Locate the
power cord that came with the DSR1024 switch. Plug one end into the power socket on the
rear of the DSR1024 switch. Plug the other end into an appropriate AC wall outlet.
WARNING: To reduce the risk of electric shock or damage to your equipment:
- Do not disable the power cord grounding plug. The grounding plug is an important safety feature.
- Plug the power cord into a grounded (earthed) outlet that is easily accessible at all times.
- Disconnect the power from the switch by unplugging the power cord from either the electrical outlet or
the appliance.
2. Plug your VGA monitor and PS/2 keyboard and mouse cables into appropriately labeled
DSR1024 switch ports. You must install both a keyboard and mouse on the local port or the
keyboard will not initialize properly.
3. Plug one end of a CAT 5 patch cable (4-pair, up to 10 meters) into the DSRIQ port and plug the
other end into the RJ-45 connector of a DSRIQ module.
4. Plug the DSRIQ module into the appropriate ports on the back of the target server. See To
connect a DSRIQ module to a server and To connect a DSRIQ module to a serial device for
more information.
5. Plug a CAT 5 patch cable from your Ethernet network into the LAN port on the back of your
DSR1024 switch. Network users will access the DSR switch through this port.
6. (Optional) The DSR1024 switch may also be accessed using a ITU V.92, V.90 or V.34-
compatible modem. Plug the included ribbon cable into the MODEM port on the back of your
DSR1024 switch. Plug the other end into the RJ-45 to DB-9 adaptor and plug the adaptor into
the connector on the modem.
NOTE: Using a modem connection instead of a LAN connection will limit the performance capability of your
DSR1024 switch.
7. (Optional) Plug one end of the cable supplied with the SPC power control device into the SPC
port on the DSR1024 switch and plug the other end into an SPC device. Plug the power cord
from the target server into the SPC device power outlets. Plug the SPC device into an
appropriate AC wall outlet.
8. If you will be configuring the DSR switch using the console menu interface, connect a terminal
or PC running terminal emulation software (such as HyperTerminal
®
) to the SETUP port on
the back panel of the DSR1024 switch using the suppliedcable. The terminal should be set to
9600 bits per second (bps), 8 bits, 1 stop bit, no parity and no flow control. Otherwise, proceed
to the next step.
9. Power up the target device and then power up the DSR1024 switch. After approximately one
minute, the switch completes initialization and displays the target video on the local
port monitor.