Filter
Top Products
Chapter 2: Installation 11
4. Prepare locations for your LongView Wireless equipment, computer
and peripherals. Place the transmitter near your computer. Best
performance is achieved when the antennas are clearly visible and free
from obstructions.
5. Connect the LongView Wireless transmitter cables into the computer’s
PS/2 keyboard (purple connector), PS/2 mouse (green connector) and
monitor connections (blue connector).
6. Using the supplied audio cable, connect one end to the LongView
Wireless transmitter’s audio input connection (lime green connector)
and the other end to the computer’s audio output connection (lime
green connector).
7. Connect your LongView Wireless transmitter to an AC power source with
one of the power supplies included with your LongView Wireless Extender.
NOTE: The transmitter must be powered up before the computer.
NOTE: Use only an Avocent-supplied power supply.
8. Power up your computer.
Connecting the LongView Wireless receiver
Virtually any industry-standard display device can be attached to the
LongView Wireless receiver, as long as it has a 15-pin D shell connector
for video input and can accept VGA (640 x 480), SVGA (800 x 600) and XGA
(1024 x 768) resolution video.
To install a LongView Wireless receiver:
1. Select a location for your LongView Wireless receiver. Find a convenient
position for locating the LongView Wireless receiver, such as a desktop
that is near your extended display. Best performance is achieved when the
antennas are clearly visible and free from obstructions.
2. Connect the extended display’s video input into the LongView Wireless
receiver’s video input (blue connector).
NOTE: The extended display must have a standard 15-pin D-shell RGB analog interface.